Sony MVS-8000 User Manual page 99

Transition Control Block and Flexi Pad Control Block (with INH
button)
a Transition type selection buttons
You can assign these buttons in setup to any
transition type (see "Overall Control Panel
Settings (Config Menu)" in Chapter 19
(Volume 3)). Press any of the following
buttons, turning it on, to select the transition
type.
Press one of these buttons, turning it on, to
determine the type of the next transition for
a background.
To select the key transition type, hold down
the [KEY1] or [KEY2] button, and press
one of the following buttons, turning it on.
When multi-program mode is selected in
the Setup menu (see "Settings for Switcher
Configuration (Config Menu)" in Chapter
20 (Volume 3)), two or more of the
following buttons may light.
qs INH button
Memory recall section
UNDO button
You can also assign a function to these
buttons to select whether or not the fader
levers are used as key frame faders.
MIX: In a background transition, the new
video fades in as the current video
fades out. During the transition, the
overall signal level is maintained at
100%.
In a key transition, the key fades in (for
insertion) or out (for removal).
NAM (non-additive mix): The current and
new video signals are compared, and
the signal with the higher luminance
level is given priority in the output.
The current video is maintained at
100% output for the first half of the
transition as the new video increases
progressively to 100%, then the current
video is progressively reduced from
Names and Functions of Parts of the Control Panel
99