3D Support; Overview - Sony MVS-8000 User Manual

3D Support

Overview

Installing the BZS-8560 switcher upgrade software in an MVS-8000G, and the
BZDM-8560 DME upgrade software in an MVE-8000A, enables the
processing of video in 3D mode.
Notes
• The following signal formats support 3D.
1080i/50, 1080i/59.94, 720P/50, 720P/59.94
• For details of the board configurations required for 3D mode, consult your
Sony representative.
Using the software
To use the switcher upgrade software and DME upgrade software, you need to
enter an install key to enable the software. (It is not necessary to enter an install
key if the software was factory-installed.)
Ask your Sony representative about entering the install key.
At this time, the unique device ID may be required.
You can check the unique device ID in the Install menu of the switcher and
DME. For details of this operation, see "Installation and Device Setup (Install/
Unit Config menu)" in Chapter 18 (Volume 3).
How the 3D display works
In 3D mode, two different images, for the left eye and the right eye, are
displayed simultaneously, to be combined by the brain into a stereoscopic
image.
Therefore, switcher and DME hardware is duplicated, with input signals for the
left eye and right eye. (See the following figure.)
511
3D Support