Sony MVS-8000 User Manual page 984

Hide thumbs Also See for MVS-8000:

Table of Contents

Background A row

If you make both pre macro and post macro settings for the same

The later setting is valid.

To set a macro attachment without changing cross-points

When you set a macro attachment to a cross-point button, you can make the

setting without changing the bus cross-points. Carry out this selection in the

Engineering Setup >Panel >Operation menu. For details, see "Setting the

Macro Execution Mode" in Chapter 19 (Volume 3).

To make a macro attachment setting in macro only mode

To carry out this operation, it is first necessary to assign the "Macro Only Set"

function to the user preference buttons in the menu control block or the utility/

shotbox control operation. Carry out this assignment in the Eng Setup >Panel

>Prefs/Utility menu. (For details, see "Setting Button Assignments (Prefs/

Utility Menu)" in Chapter 19 (Volume 3).)

To make a macro attachment in macro only mode, use the following procedure.

Macro Attachment Assigning

Background B row

The cross-point button you pressed flashes amber, and the register you

recalled in step 1 is assigned to the button.

PRE MCRO button

POST MCRO button

MCRO ATTCH ENBL button