Sony MVS-8000 User Manual page 76

For details, see "Basic Operations" in
Chapter 11 (Volume 2).
When the VTR/disk recorder/frame
memory operation mode is enabled
The buttons are used for VTR control or
playback of frame memory clips.
For details, see "Controlling the Tape/Disk
Transport" in Chapter 12 (Volume 2).
When the resizer control mode is enabled
(for the MVS-8000G only)
LOCAL (K1): Select key 1.
GLB (K2): Select key 2.
SRC (K3): Select key 3.
TRGT (K4): Select key 4.
LOC SIZE (ASP: aspect): Pressing this
button and operating the trackball or Z-
ring changes the aspect ratio of a key to
which the resizer function is applied to.
When this button is held down, the
trackball or Z-ring operation is
switched to a finer control. (fine mode)
LOC XYZ (LOC: location): Pressing this
button and operating the trackball or Z-
ring moves, shrinks, or magnifies a key
to which the resizer function is applied
to. When this button is held down, the
trackball or Z-ring operation is
switched to a finer control. (fine mode)
ROT (RSZE: resizer): Press this button,
turning it on, to enable the resizer.
CLR WORK BUFR (clear work buffer):
Pressing this button once returns the
two-dimensional transformation
settings to the defaults. Pressing twice
in rapid succession returns all resizer
parameter values to the defaults.
X, Y: These restrict the axes affected by the
trackball and Z-ring to the x- or y-axis.
Z: This restricts the axes affected by the
trackball and Z-ring to the z-axis.
CTR (center): Pressing this button once
changes the two-dimensional
transformation settings to the closest
76
Names and Functions of Parts of the Control Panel
detent values. Pressing twice in rapid
succession returns the two-dimensional
transformation settings to the defaults.
c Trackball
When the positioner operation mode is
enabled
By moving this, you can move the pattern
in the x-axis and y-axis directions.
When the three-dimensional transform
operation mode is enabled
Move the trackball to control the x- and y-
axes in a three-dimensional transform.
When the [SRC] or [TRGT] button is held
down, the trackball operation is switched to
a finer control. (fine mode)
When the resizer control mode is enabled
(for the MVS-8000G only)
By turning the trackball, you can move in
the x- and y-directions of the key to which
the resizer is applied, and change the aspect
ratio.
When the [LOC SIZE] or [LOC XYZ]
button is held down, the trackball operation
is switched to a finer control. (fine mode)
d Z-ring
When the positioner operation mode is
enabled
When the [USER] button is selected, by
turning the ring you can adjust the size of
the pattern.
When the three-dimensional transform
operation mode is enabled
Turn this ring to control the z-axis in a
three-dimensional transform.
When the [SRC] or [TRGT] button is held
down, the Z-ring operation is switched to a
finer control. (fine mode)