Hyundai KONA 2024 Owner's Manual page 73

Seats & Safety System
2C_ALRSeatBeltInstall_3
4. Slowly allow the shoulder portion of the
seat belt to retract and listen for an
audible "clicking" or "ratcheting"
sound. This indicates that the retractor
is in the "Automatic Locking" mode. If
no distinct sound is heard, repeat steps
3 and 4.
2C_ALRSeatBeltInstall_4
5. Remove as much slack from the belt as
possible by pushing down on the Child
Restraint System while feeding the
shoulder belt back into the retractor.
2C_ALRSeatBeltInstall_5
3-34
6. Push and pull on the Child Restraint
System to confirm that the seat belt is
holding it firmly in place. If it is not,
release the seat belt and repeat steps 2
through 6.
7. Double check that the retractor is in the
"Automatic Locking" mode by
attempting to pull more of the seat belt
out of the retractor. If you cannot, the
retractor is in the "Automatic Locking"
mode.
If your Child Restraint System
manufacturer instructs or recommends
you to use a tether anchor with the
lap/shoulder belt, refer to the "Installing a
Child Restraint System (CRS)" section in
this chapter.
Information
When the seat belt is allowed to retract to
its fully stowed position, the retractor will
automatically switch from the "Automatic
Locking" mode to the emergency lock
mode for normal adult usage.
WARNING
If the retractor is not in the "Automatic
Locking" mode, the child restraint can
move when your vehicle turns or stops
suddenly. A child can be seriously injured
or killed if the child restraint is not
properly anchored in the car, including
manually pulling the seat belt all the way
out to shift the retractor to the
"Automatic Locking" mode.
To remove the Child Restraint System,
press the release button on the buckle
and then pull the lap/shoulder belt out of
the Child Restraint System and allow the
seat belt to retract fully.