Hyundai KONA 2024 Owner's Manual page 198

Limitations of High Beam Assist
High Beam Assist may not work properly
in the following situations if:
• The headlights from an oncoming or
front vehicle is damaged or out of the
detection range.
• The headlights from an oncoming or
front vehicle are covered with dust,
snow, or water.
• An oncoming or front vehicle's
headlights are off but the fog lights are
on.
• There are lights that have a similar
shape as a vehicle's light ahead.
• The headlights are not repaired or
replaced properly.
• The headlights are not aimed properly.
• You are driving on a narrow curved
road, rough road, uphill, or downhill.
• A front vehicle is partially visible at a
crossroad or on a curved road.
• There is a temporary reflector or flash
ahead (construction area).
• There is a traffic light, reflecting sign,
LED sign, or reflectors ahead.
• The road is wet or covered with snow or
ice.
• A vehicle suddenly appears from a
curve.
• The vehicle is tilted due to a flat tire or
being towed.
• The headlights from an oncoming or
front vehicle is not detected because of
exhaust fumes, smoke, fog, snow,
blizzard, water spray on the road, or
windshield condensation, etc.
Information
For more information on the limitations of
the front view camera, refer to the
"Forward Collision-Avoidance Assist
(FCA) (Front View Camera Only)" or
"Forward Collision-Avoidance Assist
(FCA) (Sensor Fusion)" section in chapter
7.
WARNING
• Always check road conditions, and if
necessary, take appropriate actions to
drive safely. It is your responsibility to
operate your vehicle in a safe manner.
• If High Beam Assist does not operate
properly, use the turn signal lever to
switch between high beam and low
beam.
• High Beam Assist may not operate for
15 seconds right after your vehicle is
started or when the front view camera
is initialized.
5
5-73