Hyundai KONA 2024 Owner's Manual page 491

Emergency Situations
9.Immediately drive about 4-6 miles (7-10
km or about 10 minutes) to evenly
distribute the sealant in the tire.
2C_TMKPrecedure_5
Do not exceed a speed of 50 mph (80
km/h). If possible, do not fall below a
speed of 12 mph (20 km/h).
While driving, if you experience any
unusual vibration, ride disturbance or
noise, reduce your speed and drive with
caution until you can safely pull off of
the side of the road.
Call for road side service or towing.
10.After driving about 4-6 miles (7-10 km
or about 10 minutes), stop at a safety
location.
11.Connect the filling hose (3) of the
compressor directly to the tire valve.
2C_TMKPrecedure_3
8-24
12.Plug the compressor power cord into
the vehicle power outlet.
13.Adjust the tire inflation pressure to the
recommended tire inflation.
With the engine running, proceed as
follows:
• To increase the inflation pressure:
Switch on the compressor. To check
the current inflation pressure setting,
briefly switch off the compressor.
• To reduce the inflation pressure:
Press the button (9) on the
compressor.
NOTICE
Do not let the compressor run for more
than 10 minutes, otherwise the device
may overheat and may be damaged.
Information
The pressure gauge may show higher
than actual reading when the compressor
is running. To get an accurate tire
pressure, the compressor needs to be
turned off.
CAUTION
• If the tire inflation pressure is not
maintained, drive the vehicle a second
time, refer to step 9. Then repeat steps
10 to 13.
• Use of the Tire Mobility Kit may not be
effective for tire damage larger than
about 0.16 inches (4 mm).
Contact an authorized HYUNDAI dealer if
the tire cannot be made roadworthy with
the Tire Mobility Kit.