Hyundai KONA 2024 Owner's Manual page 481

Emergency Situations
• ALWAYS place the jack on the
designated jacking positions on the
vehicle and NEVER on the bumpers or
any other part of the vehicle for jacking
support.
• Do not start or run the engine while the
vehicle is on the jack.
• Do not allow anyone to remain in the
vehicle while it is on the jack.
• Keep children away from the road and
the vehicle.
Keep the following steps to change your
vehicle's tire:
1. Park on a level, firm surface.
2. Shift the gear to P (Park), apply the
parking brake, and press the Engine
Start/Stop button to the OFF position.
3. Press the hazard warning flasher
button.
4. Remove the wheel lug wrench, jack,
jack handle, and spare tire from the
vehicle.
5. Block both the front and rear of the tire
diagonally opposite of the tire you are
changing.
2C_SpareTireReplacementPrecedure_3
[A] Block
6.Loosen the wheel nuts
counterclockwise one turn each in the
order shown below, but do not remove
any wheel nuts until the tire has been
raised off of the ground.
8-14
2C_SpareTireReplacementPrecedure_4
7. Place the jack at the designated jacking
position under the frame closest to the
tire you are changing. The jacking
positions are plates welded to the
frame with two notches. Never jack any
other position or part of the vehicle to
prevent the vehicle slipping off of the
jack or damaging the vehicle.
2C_SpareTireReplacementPrecedure_5
8. Insert the jack handle into the jack and
turn it clockwise, raising the vehicle
until the tire clears the ground. Make
sure the vehicle is stable on the jack.
2C_SpareTireReplacementPrecedure_6