Hyundai KONA 2024 Owner's Manual page 161

Convenience Features
1. In your vehicle, press and hold the
programmed HomeLink button for 2
seconds, then release. Confirm that the
garage door is moving. AFTER it stops,
you will have one minute to complete
the following steps:
• A ladder and/or second person may
simplify the following steps.
2. On your garage door opener in your
garage, locate the 'Learn' button
(usually near where the hanging
antenna wire is attached to the garage
door opener). If there is difficulty
locating this button, reference the
device's owner's manual.
3. Press and release the 'Learn' button.
4. A light on your garage door opener may
flash, and your Two-Way
Communication indicators (4), (6) in
your vehicle may flash, confirming
completion of the process.
5. Return to the vehicle and firmly press
and release the programmed
HomeLink button to activate your
garage door. The Two-Way
Communication indicators (4), (6) flash
in orange when the door is moving. Do
not make any additional button presses
until AFTER the garage door has come
to a complete stop.
6.Your Two-Way Communication
programming is now complete.
Information
If your garage door opener has Two-Way
Communication functionality, it is
possible for HomeLink to stop functioning
the garage door shortly after initial
programming, IF the Two-Way
Communication Programming wasn't
properly completed. This usually happens
after the first 10 times a programmed
HomeLink button is pressed. If you
experience this, completing the
"Programming a New HomeLink Button"
and "Two-Way Communication
Programming" will restore door
operation.
5-36
4) Canadian Programming
Canadian radio-frequency laws require
transmitter remote signals to "time-out"
(or quit) after a couple seconds of
transmission, which may not be long
enough for HomeLink to pick up the
signal during programming.
If you live in Canada or you are having
difficulties programming a gate operator
or garage door opener by using the
programming procedures, replace
"Programming a New HomeLink Button"
step 3 with the following:
While the HomeLink indicator light (7) is
flashing orange, press and release
("cycle") your device's handheld remote
every two seconds until the HomeLink
indicator light (7) changes from orange to
green. You may now release the handheld
remote button. Then proceed with
"Programming a New HomeLink Button"
step 4.
2. Operating HomeLink®
1) Operating HomeLink®
2C_ECMHomelink_3
1. Press and release the desired
programmed HomeLink button (1, 2 or
3).