Hyundai KONA 2024 Owner's Manual page 159

Convenience Features
1. Programming HomeLink®
The following steps show how to program
HomeLink. If you have any questions or
are having difficulty programming your
HomeLink buttons, refer to the HomeLink
website or call the HomeLink customer
support toll-free number. Do this, before
going back to the dealer who sold you the
vehicle.
• Visit the HomeLink website at:
www.homelink.com. Then at the top of
the page, choose your vehicle make.
Then watch the You Tube video, and/or
access additional website information.
• If you choose to access the website via
your cell phone, scan the QR code.
2C_ECMHomelinkQR
• Or, call HomeLink customer support at
1-800-355-3515 (Please have the
vehicle make/model AND the opener
device make/model readily available.)
1) Programming Preparation
2C_ECMHomelink_2
1. When programming a garage door
opener, it is advised to park the vehicle
outside of the garage.
2. It is recommended that a new battery
be placed in the handheld transmitter
of the device being programmed to
HomeLink for quicker training and
accurate transmission of the
radio-frequency signal.
5-34
3. Press the Start/Stop button to the ACC
(Accessory) position for programming
of HomeLink.
2) Programming a New HomeLink®
2C_ECMHomelink_3
1. Press and release the HomeLink button
(1), (2) or (3), you would like to program.
The HomeLink indicator light (7) will
flash orange slowly (if not, perform the
steps of "Erasing HomeLink Buttons"
section, and start over).
2C_ECMHomelink_4
2. Position the garage door opener
remote 1-3 inches (2-8 cm) away from
the HomeLink buttons.
3. While the HomeLink indicator light (7) is
flashing orange, press and hold the
handheld remote button. Continue
pressing the handheld remote button
until the HomeLink indicator light (7)
light changes from orange to green.
You may now release the handheld
remote button.
4. Wait until your garage door comes to a
complete stop, regardless of position,
before proceeding to the next steps.