Table of Contents
Advertisement
2. Checking the contour of a sewing pattern
WARNING :
1. Make sure without fail of the contour of the sewing pattern after selection of the sewing pattern.
If the sewing pattern extends outside the work clamp feet, the needle will interfere with the work
clamp feet during sewing, causing dangerous troubles including needle breakage.
2. When making sure of the contour of the sewing pattern, press + / - key with the needle bar lowered,
and the work clamp feet move after automatically making the needle bar return to the upper posi-
tion.
h
h
2
1
d
Clearance
1
Needle
3
Clearance
2
) Press
key to make the READY LED light up.
2) Select the work clamp foot lowering
key.
3) Lower the work clamp feet with the foot switch.
The sewing machine does not start
even when the foot switch is de-
pressed under this mode.
4) Press
key in the state that the work clamp
feet are lowered.
The work clamp feet do not go up even
when the foot switch is detached.
5) Confirm the contour of the pattern with
or
key.
6) The work clamp feet will go up when
pressed.
The work clamp feet do not come down
immediately after turning ON the power.
(Caution) When using a sewing pattern which is
full in lengthwise direction (+10 mm),
make sure of the clearance between
cloth feed base 2 and wiper base 1 . If
there is no clearance, loosen setscrew
3 and move the wiper to the needle
side. Especially when the needle po-
sition comes to the rear on the right
side, the clearance is decreased.
9
－
－
with
key
key is
Advertisement
Table of Contents
