Table of Contents
Advertisement
5-4. Checking the contour of a sewing pattern
WARNING :
1. Make sure without fail of the contour of the sewing pattern after selection of the sewing pattern.
If the sewing pattern extends outside the work clamp feet, the needle will interfere with the work
clamp feet during sewing, causing dangerous troubles including needle breakage.
2. When making sure of the contour of the sewing pattern, press + / - key with the needle bar lowered,
and the work clamp feet move after automatically making the needle bar return to the upper posi-
tion.
❷
❸
❷
When using a sewing pattern which is full in lengthwise direction (+10 mm), make sure of the
clearance between cloth feed base ❷ and wiper base ❶ . If there is no clearance, loosen setscrew
❸ and move the wiper ❹ to the needle side. Especially when the needle position comes to the
rear on the right side, the clearance is decreased.
❼
1) Press READY key
2) Press work PRESSER and WINDER key
3) Display the shape check screen with + key
❺
❼
❾
4) Check the shape with DATA CHANGE key
5) Press RESET key
Clearance
❶
Needle
－
－
21
READY LED .
❺ to display "work clamp lowering screen".
❼ .
Under this mode, the sewing machine will
not start running even if you depress the
pedal.
❼ .
sewing starting position and lift the work clamp.
When you press RETURN key
sewing screen is displayed at the current posi-
tion.
When you depress the pedal in the aforemen-
tioned state, the sewing machine starts sewing
from the current position.
❸
Clearance
❶
❹
❷ to light up the SET
❸ to return to the
❾ , the
❷
Advertisement
Table of Contents
