JUKI LK-1901AN Instruction Manual page 47

Indication Function
State of work clamp foot when
machine stopped by temporary
stop command can be selected.
Needle bar stop position is set.
Thread trimming can be pro-
hibited.
Route of origin return by means
of clear key can be selected.
Bobbin winding speed can be set.
Operation timing of material
closing is selected.
LK-90AN only
Wiper operation method can
be selected.
Tie stitching at the start of
sewing of the pattern for but-
ton sewing can be prohibited.
For LK-903AN only
Position of origin moves 5 mm
to the front.
This function sets whether or
not the calling of the pattern
data is operative.
Grease replenishing time in-
formation counter
Register of the pattern is per-
formed.
Register of the cycle stitching
is performed.
Setting range State when delivered
0 : Work clamp foot goes up.
 : Work clamp foot goes
u p w i t h w o r k c l a m p
foot switch.
2 : Lift of work clamp foot
is prohibited.
0 : UP position
 : Upper dead point
0 : Normal
 : Thread trimming pro-
hibited
0 : Straight line return
 : Reverse return of pattern
800 to 2,000
0 : Output prohibited
 : Operation when work
clamp foot comes down.
2 : Operation at the time
of start
0 : Without wiper at the
time of thread trimming
on the way
 : With wiper at the time
of thread trimming on
the way 1
2 : With wiper at the time
of thread trimming on
the way 2
3 : Magnet wiper
0 : Tie stitching effective
 : Tie stitching ineffective
0 : Standard
 : Front
0 : Calling inoperative Setting depends on
 : Calling operative
44
－ －
0
0 Needle bar rotates in the re-
verse direction after the UP
position stop and stops when
upper dead point stop is set.
0
0 This function is used when
straight line return from the
midway of pattern to the start
of sewing is not possible.
600 Max. speed limitation has priority.
2 For the machines other than
LK-90AN, this function is
not indicated.

1 : Without return of the last wiper
2 : With return of the last wiper
0 For the machines other than
LK-903AN, thus function is
not indicated.
0 Necessary to set this function
when using work clamp foot
and pattern of LK-904
Service pattern Nos.  to 64
the model used. can be individually set.
– Refer to the item
Replenishing the designated
places with grease" p.37.
Refer to the item
Performing sewing using
the pattern keys" p. 24.
Refer to the item
Performing sewing using the
combination function" p. 27.
Remarks
"!.[7]-11.
"! .[6]-1.
"! .[6]-2.