Weber SmokeFire EX4 Owner's Manual page 28

Wood pellet barbecue
Hide thumbs Also See for SmokeFire EX4:
Table of Contents

Advertisement

TROUBLESHOOTING
Replacing the Glow Plug
Contact WEBER Customer Service at weber.com for a replacement glow
plug. To replace the glow plug, please follow these steps:
1. Open the barbecue lid and shutdown the barbecue by pushing and
holding the dial or using the main menu. Wait until the barbecue has
completed the shutdown procedure and completely cooled.
CAUTION: Do not unplug the barbecue or turn it off during the shutdown
procedure.
2. Once the barbecue has completed the shutdown procedure, power off
the barbecue (A) and unplug from power source.
3. Open the barbecue lid and remove the cooking grates, FLAVORIZER
BARS, heat diffuser, and heat baffle from the cookbox. B
4. From the rear of your SMOKEFIRE barbecue, remove the rear access
panel by removing four screws (C).
5. Unplug the glow plug assembly wire by pinching and pulling the
quick disconnect plug (D).
6. Carefully remove the glow plug assembly by removing the bracket
screw that holds it in place and sliding the assembly out from the
barbecue (E).
7. Remove the glow plug from the glow plug assembly by pulling it out
and away (F).
8. Install the replacement glow plug into the glow plug assembly by
firmly pushing it into the socket (G).
9. Carefully reinstall the glow plug assembly straight through the back
of the barbecue, and secure it in place by tightening the bracket
screw (H).
NOTE: Be sure that the tip of the glow plug has been properly installed by
visually inspecting the glow plug at the bottom of the burn pot inside the
cookbox. The tip of the glow plug must be inserted through the pellet grate
for proper operation (I).
10. Reconnect the glow plug assembly wire connector (J).
11. Reinstall the rear access panel (K).
12. Reinstal the heat baffle, heat diffuser, FLAVOURISER bars and
cooking grates inside the cookbox. L
13. Plug the power cord into the barbecue located underneath the
hopper, then plug the barbecue into a power source.
14. Power on the barbecue and confirm replacement of the glow plug
within the main menu settings of the controller.
28
A
B
C
D

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smokefire ex6

Table of Contents