Weber SmokeFire EX4 Owner's Manual page 25

E7 Motor Failure
Checking Motor Electrical Connection
To clear the E7 error code from the controller, please follow these steps:
1. When the barbecue has completed the shutdown procedure and
completely cooled, power off the barbecue and unplug from power
source (A).
2. From the rear of your SMOKEFIRE barbecue, remove the rear access
panel by removing four screws (B).
3. Check the electrical connection on the motor (C). Make sure the
connector is securely joined to the motor.
4. Reinstall the rear access panel (D).
5. Plug in, power on the barbecue, and begin a cooking session to allow
the controller to run diagnostics.
6. If the E7 error code still remains on the controller, contact the
Customer Service Representative in your area using the contact
information on our website for motor replacement.
TROUBLESHOOTING
A
B
C
D
25
weber.com