Weber SmokeFire EX4 Owner's Manual page 21

Wood pellet barbecue

Hide thumbs Also See for SmokeFire EX4:

Table of Contents

7. Remove the auger/motor assembly by first removing two screws and

washers from the mounting bracket (F). Carefully slide and twist the

auger/motor assembly out and away from the barbecue (G).

NOTE: Visually note the orientation of the motor when installed on the barbecue.

Clean the auger tube and auger/motor assembly to remove any pellets

and debris that may have been jamming the auger.

9. Before reinstalling the auger/motor assembly back into the auger tube,

verify that the shear pin is still intact (H). Both sides of the pin should be

fully engaged and visible. The auger should not pull away from the motor.

If the shear pin is broken, it should be replaced before reassembling.

Contact a WEBER Customer Service Representative in your area using

the contact information on our website for a replacement.

10. Reinstall the auger/motor assembly by sliding the auger through the

auger tube and fastening the assembly with two screws and washers (I).

CAUTION: Make sure the auger/motor assembly is in the correct orientation when

reinstalling into the auger tube. See illustration (J).

11. Connect the motor's electrical connection. Make sure the connector is

securely joined to the motor (K).

TROUBLESHOOTING

weber.com

Table of Contents

Smokefire ex6