Weber SmokeFire EX4 Owner's Manual page 24

Wood pellet barbecue

Hide thumbs Also See for SmokeFire EX4:

Table of Contents

TROUBLESHOOTING

E3 Barbecue Flame is Out

Barbecue Flame Out Procedure

To clear the E3 error code from the controller, please follow these steps:

1. The barbecue will automatically run the shutdown procedure if

the barbecue is still hot. Open the barbecue lid and wait until the

barbecue has completed the shutdown procedure and completely

cooled.

CAUTION: Do not unplug the barbecue or power it off during the shutdown

procedure.

2. Once the shutdown procedure is complete, power off the barbecue

and unplug from power source (A).

3. Open the barbecue lid and remove the cooking grates, FLAVORIZER

BARS, heat diffuser, and heat baffle from the cookbox (B).

4. Clean the cookbox and burn pot of any ash or debris using a barbecue

brush or scraper to direct it into the ash and grease system (C).

CAUTION: Allow time for the ash and debris to fully extinguish before cleaning

the barbecue.

5. Reinstall the heat baffle, heat diffuser, FLAVORIZER bars and cooking

grates inside the cookbox (D).

6. Remove and clean any ash or grease from inside the ash and grease

system. Once cleaned, reinstall the drawer (E). Replace disposable

drip pans as needed.

7. Plug the barbecue into the power source and power on the barbecue

to begin your cooking session.

Table of Contents

Smokefire ex6