Weber SmokeFire EX4 Owner's Manual page 26

Wood pellet barbecue

Hide thumbs Also See for SmokeFire EX4:

Table of Contents

TROUBLESHOOTING

E9 Low Fuel Detection Error

Cleaning Fuel Sensor Window

To clear the E9 error code from the controller, please follow these steps:

1. When the barbecue has completed the shutdown procedure and

completely cooled, from the rear of your SMOKEFIRE barbecue, set a

large bucket or container underneath the middle of the hopper (A).

2. Pull the hopper slide door located on the rear of the hopper to

release the pellets into the container below (B).

3. Using a dry cloth or paper towel, wipe the low fuel sensor window

until cleaned (C).

4. Push the hopper slide door closed (D), and refill the hopper with your

choice of WEBER SMOKEFIRE ALL NATURAL HARDWOOD PELLETS.

5. Power on the barbecue and begin a cooking session to allow the

controller to run diagnostics.

6. If the E9 error code still remains on the controller, Contact the

Customer Service Representative in your area using the contact

information on our website for low fuel sensor replacement.

Table of Contents

Smokefire ex6