Attaching Ends - Hussmann PMM20F3R Installation Manual

INSTALLATION
3.11

ATTACHING ENDS

Attaching Ends
1. Foam tape is pre-installed onto the case end. If
foam tape is damaged or worn, replace before
installing new end.
2. Ensure case is in its final position and is levelled,
and line up end with frame holes as seen in Figure
3AD.
3. Screw bolts in through the frame side of the case
ensuring that the end is level to the ground and is
touching the foam tape at all sides of the frame to
ensure a good seal is formed.
4. Tighten bolts.
5. Gaps between the frame and the end can be sealed
with a matching colour silicone filler, applied neatly
and uniformly across the length of the end.
FIGURE 3AD
PAGE 24
Attaching End Bumpers
1. To attach the end bumper, insert the bumper
bracket into the holes as per Figure 3AE.
2. Screw bolts in through the frame side of the case,
ensuring that the bumper is level with the ground
and is aligned with the front bumper.
3. Tighten bolts.
FIGURE 3AE
Attaching End Kickplates
1. Screw the kickplate bracket to the frame as per
Figure 3AF.
2. Screw the kickplate onto the bracket as per Figure
3AG, ensuring that the edge of the kickplate is flush
with the front kickplate
FIGURE 3AF
FIGURE 3AG
PMM20F3R MULTIDECK - HUSSMANN
.