Attaching Kickplates - Hussmann MPD116 Installation Manual

Medium temperature remote cabinet, multideck door
Table of Contents

Advertisement

INSTALLATION
3.7
JOINING THE CASES
SMART LOOK SYSTEM
5. Apply either black or white silicon (depending on
the interior colour of the case) all the way along
the top of the join, between the endframes of the
cases, only.
6. Finish the silicon neatly.
Seal along this edge only when cases are
joined together
PAGE 22
DOOR HANDLES
Depending on door type, door handles will be
factory fitted, but some may become loose during
transportation of the case.
Insert Multiplexing
Check handles and tighten if necessary.
rods
Common between square
and curved canopies
FIGURE 3U
FIGURE 3W - Door Handles Are Secure
3.8
(This should be done after final Installation of
Refrigeration and Drainage connections)
FIGURE 3V
ATTACHING KICK PLATES
Use hex screws 6.3 x 19mm to fix the kickplate
support to the base. (These parts are in the
accessories box).
Do NOT fix the kickplate support to the base too
tightly. It should be able to slip up and down
through the oblong hole. This will enable the
kickplate to be moveable and it will naturally sit
correctly in relation to the floor.
MPD GLASS DOOR MULTIDECK - HUSSMANN
Bentcam Door

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mpd216Mpd316Mpd118Mpd218Mpd318

Table of Contents