Attaching Kickplates - Hussmann PMM20F3R Installation Manual

INSTALLATION
3.9 JOINING THE CASES
5. Apply either black or white silicon (depending on
the interior colour of the case) all the way along the
top of the join, only between the endframes of the
cases.
6. Finish the silicon neatly.
Seal along this edge only when cases are
joined together
PAGE 22
3.10
(This should be done after final installation of
refrigeration and drainage connections)
• Use hex screws 6.3 x 19mm to fix the kickplate
support to the base. These parts are in the
accessories box.
• Do NOT fix the kickplate support to the base too
tightly. It should be able to slip up and down
through the oblong hole. This will enable the
kickplate to be moveable and it will naturally sit
correctly in relation to the floor.
FIGURE 3Y
On patch or crown end kickplates, cut the profile seal
in a 45
front kickplate panel.

ATTACHING KICKPLATES

angle in order to attach it to the bottom of the
0
PMM20F3R MULTIDECK - HUSSMANN
FIGURE 3Z