Using Rtsi As Outputs - National Instruments PXI-6289 User Manual

RTSI 7
RTSI 6
RTSI 5
RTSI 4
RTSI 3
RTSI 2
RTSI 1
RTSI 0
Not Connected. Do not connect signals to these terminals.
D GND

Using RTSI as Outputs

RTSI <0..7> are bidirectional terminals. As an output, you can drive any of the following signals
to any RTSI terminal:
• AI Start Trigger (ai/StartTrigger)
• AI Reference Trigger (ai/ReferenceTrigger)
• AI Convert Clock* (ai/ConvertClock)
• AI Sample Clock (ai/SampleClock)
• AI Pause Trigger (ai/PauseTrigger)
• AO Sample Clock* (ao/SampleClock)
• AO Start Trigger (ao/StartTrigger)
• AO Pause Trigger (ao/PauseTrigger)
• 10 MHz Reference Clock
Counter n Source, Gate, Z, Internal Output
•
• Change Detection Event
• Analog Comparison Event
• FREQ OUT
• PFI <0..5>
Note Signals with a * are inverted before being driven on the RTSI terminals.
Table 9-1. RTSI Signals
RTSI Bus Signal
M Series User Manual
Terminal
34
32
30
28
26
24
22
20
1 to 18
19, 21, 23, 25, 27, 29, 31, 33
© National Instruments | 9-5