JVC CL-R190 Instruction Manual page 11

The model CL-R190 is intended for use in an electromagnetic environment in which radiated
RF disturbances are controlled. The customer or the user of the model CL-R190 can help
prevent electromagnetic interference by maintaining a minimum distance between portable and
mobile RF communications equipment (transmitters) and the model CL-R190 as recommended
below, according to the maximum output power of the communications equipment.
Rated maximum
output power of
transmitter
W
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended
separation distance d in meters (m) can be estimated using the equation applicable to the
frequency of the transmitter, where P is the maximum output power rating of the transmitter in
watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures, objects and people.
Cables used for the test
Power cord
DVI cable (DVI - DVI)
DisplayPort cable (DP - DP)
Please read the label containing warnings and cautions carefully before use.
Important
Separation distance according to frequency of transmitter
150 kHz to 80 MHz
d = 1.2
0.12
0.38
1.2
3.8
12
Length
1.8 m
1.8 m
1.8 m
Label
- 11 -
m
80 MHz to 800 MHz
d = 1.2
0.12
0.38
1.2
3.8
12
800 MHz to 2.7 GHz
d = 2.3
0.23
0.73
2.3
7.3
23
English