Figure 4-2 Menu 2 - Switch Setup; Table 4-B Menu 2 - Switch Setup - ZyXEL Communications VES-1000 Series User Manual

VES-1000 Series Ethernet Switch
Press Space Bar to Toggle.
FIELD
VDSL Mode
VDSL Modem Firmware
Auto Upgrade
Ethernet Port 13 and Port
14 Trunking
Edit Spanning Tree
Protocol
Edit GARP Timer
VLAN Type
IGMP Snooping
Edit QoS Support
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to save your
configuration, or press [ESC] at any time to cancel.
4-2
VDSL Mode= 10BaseS
VDSL Modem Firmware Auto Upgrade= Yes
Ethernet Port 13 and Port 14 Trunking= No
Edit Spanning Tree Protocol= No
Edit GARP Timer= No
VLAN Type= 802.1Q
IGMP Snooping= Disable
Edit QoS Support= No
Press ENTER to Confirm or ESC to Cancel:

Figure 4-2 Menu 2 - Switch Setup

Table 4-B Menu 2 – Switch Setup
Press [SPACE BAR] and then press [ENTER] to choose from
10BaseS, ETSI Plan 997 or ANSI/ETSI Plan 998.
Press [SPACE BAR], select Yes, and then press [ENTER] to allow
automatic firmware upgrade of the subscribers VDSL modem.
Ethernet port trunking is disabled by default. Press [SPACE BAR],
select Yes, and then press [ENTER] to allow trunking (make sure the
remote switch also supports trunking).
Enable trunking (press [SPACE BAR], select Yes) only if you connect
both Ethernet ports to a single switch. (Ethernet ports 13 & 14 relate
to the VES-1012 switch only).
Press [SPACE BAR] once to select Yes and then [ENTER] to display
Menu 2.1 - Spanning Tree Protocol Setup.
Press [SPACE BAR] once to select Yes and then press [ENTER] to
go to Menu 2.2 — GARP Timer Setup.
Press [SPACE BAR] and then press [ENTER] to choose from 802.1Q
or Port-Based. See section 4.2.8 for more information on VLANs. To
enable IEEE 802.1Q on the VES-1000 Series switch, you must
configure it for the switch in this menu, menu 6 port submenu(s) and
menu 17 VLAN setup. Menu 17 is not applicable (N/A) if you choose
port-based VLANs for the switch in menu 2.
Press [SPACE BAR] once to select Enable and then press [ENTER].
Press [ENTER] again at the message "Press ENTER to Confirm..." to
activate IGMP snooping on the device.
Press [SPACE BAR] once to select Yes and then press [ENTER to
go to Menu 2.3 — QoS Setup.
Menu 2 - Switch Setup
DESCRIPTION EXAMPLE
10BaseS
Yes
No
No
No
802.1Q
Disable
No
General, Switch and IP Setup