Figure 12-10 Ethernet Flow Control; Figure 12-11 Ethernet Monitor Status; Table 12-G Ethernet Speed Parameters - ZyXEL Communications VES-1000 Series User Manual

Type this command to set the Ethernet port speed of the VES-1000 Series switch (with "lt") or VDSL subscriber
modem (with "nt"). Speed parameters are explained in the following table.
12.3.4 Enet Fctrl Command
vdsl enet fctrl chan-id (lt|nt) [on|off]
Type this command to set the Ethernet port flow control or show the Ethernet port flow control status (without
"on" or "off"). By default, flow control is on for full duplex Ethernet connections and off for half duplex Ethernet
connections.
12.3.5 Enet Monitor Command
vdsl enet monitor chan-id [on|off]
When this flag is on this command automatically displays the VES-1000 Series switch (and the subscriber's
VDSL modem's Ethernet statistics if the link is up) every five seconds. Enter the command without "on" or "off"
to just show the Ethernet monitor status.
VDSL-Related Commands

Table 12-G Ethernet Speed Parameters

SPEED INDEX NUMBER
0
1
2
3
4
ves-100>vdsl enet fctrl 2
enet flow control(LT): on

Figure 12-10 Ethernet Flow Control

ves-100>vdsl enet monitor 2
enet monitor flag: off

Figure 12-11 Ethernet Monitor Status

VES-1000 Series Ethernet Switch
SPEED/FLOW CONTROL
Auto Negotiation
10 Mbits/s, Half Duplex
10 Mbits/s, Full Duplex
100Mbits/s, Half Duplex
100Mbits/s, Full Duplex
12-11