Figure 10-14 Telnet Into Menu 24.7.2 - System Maintenance - ZyXEL Communications VES-1000 Series User Manual

VES-1000 Series Ethernet Switch
Menu 24.7.2 — System Maintenance — Upload System Configuration File
To upload the system configuration file, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system. Then type "root" and
SMT password as requested.
3. Type "put configurationfilename rom-0" where "configurationfilename"
is the name of your system configuration file on your workstation, which
will be transferred to the "rom-0" file on the system.
4. The system reboots automatically after the upload system configuration
file process is complete.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading system firmware using TFTP (note
that you must remain on this menu to upload system firmware using TFTP),
please see your manual.
Press ENTER to Exit:

Figure 10-14 Telnet Into Menu 24.7.2 - System Maintenance

To upload the firmware and the configuration file, follow these examples
10.4.3 FTP File Upload Command from the DOS Prompt Example
Launch the FTP client on your computer.
Step 1.
Enter "open", followed by a space and the IP address of your VES-1000 Series switch.
Step 2.
Press [ENTER] when prompted for a username.
Step 3.
Enter your password as requested (the default is "1234").
Step 4.
Enter "bin" to set transfer mode to binary.
Step 5.
Use "put" to transfer files from the computer to the VES-1000 Series switch, for example, "put
Step 6.
firmware.bin ras" transfers the firmware on your computer (firmware.bin) to the VES-1000 Series
switch and renames it "ras". Similarly, "put config.rom rom-0" transfers the configuration file on your
computer (config.rom) to the VES-1000 Series switch and renames it "rom-0". Likewise "get rom-0
config.rom" transfers the configuration file on the VES-1000 Series switch to your computer and
renames it "config.rom." See earlier in this chapter for more information on filename conventions.
Enter "quit" to exit the ftp prompt.
Step 7.
10.4.4 FTP Session Example of Firmware File Upload
10-10 Firmware and Configuration File Maintenance