Table of Contents
Advertisement
10-3．Operation
Warning: Electric Shock
• Always be sure to turn off the breaker before installing or removing devices using
AC output receptacles.
Caution: Injury
• Always be sure to turn off the power switches of all devices using the equipment
when turning on the equipment breaker. Leaving on the power switch of a device
using the equipment when the equipment breaker is turned on could result in the
sudden operation of the corresponding device.
• Do not leave on the power switch of a device using the equipment and do not
connect a device to an AC output terminals.
Caution: Physical and Secondary Damage
• If using the equipment as a power source for medical equipment, you must
check with the medical equipment manufacturer, doctor and hospital before
using the equipment.
1)
Turn off the switches of devices being used.
2)
Turn the breaker (1-P) to "OFF".
3)
Start the engine. (Refer to section "8-1. Starting
the Engine".)
4)
Connect the power plug(s) of device(s) being used
to the AC output terminals.
5)
Turn the breaker (1-P) to "ON".
■Recovery from Overcurrent Breaker Operation
Caution: Injury
• Always be sure to turn off the power switches of all devices using the equipment
when turning on the equipment breaker. Leaving on the power switch of a device
using the equipment when the equipment breaker is turned on could result in the
sudden operation of the corresponding device.
The Breaker operates when there is excessive current to isolate the corresponding
circuit.
Inspect the breaker if a device being used stops during equipment operation.
Follow the following procedures to recover operation when the breaker operates due
to overcurrent.
1)
Turn off all switches of devices using the equipment as an AC power source.
2)
Push up the breaker lever that has operated to the "ON" position.
<Note>
• Refer to section "10-2. Usable Device Capacities" and be careful of overloading.
- 23 -
1-P Breaker
Advertisement
Table of Contents
