Table of Contents
Advertisement
Section3
Setting the Logging Conditions
■ EXT INPUT SLOPE
This item is for setting the external input signal as the logging end trigger.
FUN Mode-[LOGGING]-[TRIGGER]-[END]-[EXT]
EDGE
■ DATA SLOPE
This item is for setting the change in the state of the data (measured value) as the log-
ging end trigger. Set the trigger level. When the data falls above or below this preset
trigger level value, this is taken to be the end trigger.
FUN Mode-[LOGING]-[TRIGGER]-[END]-[DATA]
ASSIGN
EDGE
ZS-DSU
3-22
User's Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Setting
Select at which timing, ON or OFF, of the timing signal that logging is to
end.
Range: OFF→ ON, ON→ OFF (default value: OFF→ ON)
Delays end of logging by about 1.2 ms at most from input of the
external trigger.
Timing input
At OFF
At ON
Setting
Select the source to be used as the logging end trigger.
Range: SourceA to J
Select whether above or below the trigger level is to be used as the end
trigger. Then, also set the trigger level.
Range: UP, DOWN (default: UP)
At up edge
At down edge
Description
ON
OFF
1.2ms
ON
Logging end
OFF
Logging end
Description
Logging end
Logging end
1.2ms
Trigger level
Measured value
Advertisement
Table of Contents
