Ndis 4.0 (Windows Nt) Driver Messages - IBM x 340 Series Hardware Maintenance Manual

Table 3. NDIS 2.01 (OS/2) driver messages for the Ethernet controller.
PCNTND-15 Device not found.
PCNTND-16 PCI scan specified, device not found.
PCNTND-21 The adapter failed the checksum test.
PCNTND-23 WARNING: PCNET IRQ found = xx
PCNTND-24 WARNING: PCNET IRQ does not match PROTOCOL.INI.
PCNTND-25 PCI scan specified, PCI bus not found!
PCNTND-29 WARNING: DMA number is not necessary for PCI device.
PCNTND-33 PCNET device with specified IOBASE is already in use.

NDIS 4.0 (Windows NT) driver messages

Explanation: The driver cannot find an Ethernet controller in the server.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is
enabled, go to "Starting the diagnostic programs" on page 14 to run the diagnostic
programs.
Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is
enabled, go to "Starting the diagnostic programs" on page 14 to run the diagnostic
programs.
Explanation: The driver cannot find an Ethernet controller.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is
enabled, go to "Starting the diagnostic programs" on page 14 to run the diagnostic
programs.
Explanation: The interrupt request (IRQ) setting (xx) in the PROTOCOL.INI file does
not match the hardware IRQ setting. Action: Remove the IRQ setting from the
PROTOCOL.INI file or change the IRQ setting in the PROTOCOL.INI file to match the
IRQ setting shown in the PCI Slot/Device Information selection of the Advanced Setup
menu in the Configuration/Setup Utility program.
Explanation: The interrupt request (IRQ) setting in the PROTOCOL.INI file does not
match the hardware IRQ setting. Action: Remove the IRQ setting from the
PROTOCOL.INI file or change the IRQ setting in the PROTOCOL.INI file to match the
IRQ setting shown in the PCI Slot/Device Information selection of the Advanced Setup
menu in the Configuration/Setup Utility program.
Explanation: The driver cannot locate the PCI bus.
the diagnostic programs.
Explanation: The Ethernet controller does not require a DMA setting.
Action: Remove the DMA setting in the PROTOCOL.INI file.
Explanation: The specified I/O address number is already in use by another Ethernet
controller or device.
Action: Remove the I/O address setting in the PROTOCOL.INI file.
This section contains the error messages for the NDIS 4.0 drivers. The explanation and
recommended action are included with each message.
Action: Run
23
Diagnostics