Ethernet Controller Messages; Ndis 4.0 (Windows Nt And 2000) Driver Messages - IBM IntelliStation 6836 Hardware Maintenance Manual

Ethernet controller messages

The integrated Ethernet controller might display messages from the Network
driver interface specification (NDIS) adapter for level 4.0 (Windows NT).

NDIS 4.0 (Windows NT and 2000) driver messages

This section contains the error messages for the NDIS 4.0 drivers. The explanation
and recommended action are included with each message.
Diagnostic Error Code
217-000-XXXHard Disk Drive Test Passed
217-25X-XXX 217-26X-XXXHard Disk Drive
(IDE) error
217-28X-XXX 217-29X-XXXHard Disk Drive
(SCSI) error
220-000-XXXHi-Capacity Cartridge Drive
Test Passed
220-XXX-XXXHi-Capacity Cartridge Drive
error
301-XXX-XXXKeyboard error
301-000-XXXKeyboard Test Passed
302-000-XXXMouse Test Passed
302-XXX-XXXMouse error
303-000-XXXJoystick Test Passed
303-XXX-XXXJoystick error
305-000-XXXMonitor DDC Test Passed
305-250-XXXMonitor DDC self test failure
415-000-XXXModem Test Passed
415-XXX-XXXModem error
FRU/Action
1. No action
1. Hard Disk Drive Cable
2. Check power supply voltages
3. Hard Disk drive (IDE)
4. System board
1. Hard Disk Drive Cable
2. Check power supply voltages
3. Hard Disk drive (SCSI)
4. SCSI adapter card
5. System board
1. No action
1. Remove the Hi-Capacity Cartridge
Drive and re-test the system
1. Keyboard
2. Check and test mouse
3. System board
1. No action
1. No action
1. Mouse
2. Check and test Keyboard
3. System board
1. No action
1. Remove the Joystick and re-test the
system
1. No action
1. Run Setup to enable DDC
2. Cable
3. Monitor
4. Video card
5. System board
1. No action
1. Remove the Modem and re-test the
system
Chapter 7. Symptom-to-FRU index
103