Controls And Indicators - IBM x 340 Series Hardware Maintenance Manual

Controls and indicators

CAUTION:
The power control button on the device and the power switch on the power supply
do not turn off the electrical current supplied to the device. The device also might
have more than one power cord. To remove all electrical current from the device,
ensure that all power cords are disconnected from the power source.
The most commonly used controls and status indicators are on the front panel of the
server.
Ñ1Ö AC power light
Hard Disk Status light
Ñ2Ö
Ñ3Ö Hard disk Activity light
Ñ4Ö System power light
Ñ5Ö Power control botton
Ñ6Ö Reset button
System Power Light: When this green light is on, system power is present in the
server. When this light flashes, the server is in standby mode (the system power
supply is turned off and AC current is present). When this light is off, either a power
supply, AC power, or a light has failed.
Attention: If this light is off, it does not mean there is no electrical current present in
the server. The light might be burned out. To remove all electrical current
from the server, you must unplug the server power cords from the
electrical outlets or from the UPS.
Power Control Button: Press this button to manually turn the server on or off.
7
General information