IBM x 340 Series Hardware Maintenance Manual page 62

c 1 d
c 2 d
c 3 d
c 4 d
c 5 d
To install a non-hot-swap drive:
1.
2.
3.
4.
5.
6.
7.
54
Hardware Maintenance Manual: xSeries 340 Model 6RY
Slide rails
Filler panel
Slide rail
Drive
Slide rail
Review the information in"Before you begin" on page 45.
Turn off the server and peripheral devices and then remove the cover. (See
"Removing the cover and bezel" on page 47 .)
Remove the trim bezel.
Remove the filler panel from the bay opening by pulling the filler panel away
from the server. You do not need the filler panel when you have a drive installed
in the bay.
Note: The server's EMI integrity and cooling are protected by having the non-
hot-swap bays covered or occupied. When you install a drive, save the
filler panel from the bay, in case you later remove the drive and do not
replace it with another.
Touch the static-protective bag containing the drive to any unpainted metal
surface on the server; then, remove the drive from the bag and place it on a static-
protective surface.
Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
Install rails on the drive.
• If you are installing a standard-size drive:
a. Pull the blue slide rails off the back of the filler panel.