Information For Windows Nt Workstation Users Only; Setting Up Your Hard Disk Partitions; Microsoft Network Setup Wizard; Additional Setup Tasks - IBM IntelliStation M Pro Type 6868 User Manual

Information for Windows NT Workstation users only

The following information is for computers running Windows NT
Workstation only.

Setting up your hard disk partitions

Your hard disk has a 2 GB partition (referred to as drive C). This partition
contains Windows NT Workstation and the other preinstalled software.
Important: The remaining hard disk space has been left unformatted and
cannot be used until you partition it.
You can format and partition hard disk space into multiple drives (such as
C, D, and E) as you wish. For example, if you want to install another
operating system, it can be installed into a separate primary partition.
To set up your hard disk partitions:
1. In the Access IBM menu, click Start up.
2. In the Start up menu, click Partition your hard disk.
3. Disk Administrator starts. If you need more information about
partitioning your hard disk, click Help on the Disk Administrator
screen.
4. After creating your hard disk partitions, close the Disk Administrator
program.

Microsoft Network Setup Wizard

Microsoft Network Setup Wizard gives you access to the Internet. To begin
setting up Windows NT Workstation Networking, click Set Up Your
Network. You will be asked if you wish to install Windows NT
Workstation Networking now. To continue with the setup procedure, click
Yes, and the Microsoft Network Setup Wizard will open. For information
about using the Microsoft Network Setup Wizard, see the Windows NT
Workstation manual.

Additional setup tasks

This section includes information about several tasks that you might want
to perform as part of the setup of your computer. These tasks are optional,
but you should consider performing each of them before completing the
setup.
Creating an IBM Enhanced Diagnostic diskette
Chapter 2. Setting up your computer
19