IBM x 340 Series Hardware Maintenance Manual page 124

Error Code/Symptom
011-XXX-000 (Failed COM1 Serial
Port test)
011-XXX-001 (Failed COM2 Serial
Port test)
014-XXX-000 (Failed Parallel Port
test)
015-XXX-001 (USB interface not found,
board damaged)
015-XXX-015 (Failed USB external loopback
test)
015-XXX-198 (USB device connected during
USB test)
020-XXX-000 (Failed PCI Interface
test)
(Failed Hot-Swap
020-XXX-001
Slot 1 PCI Latch test)
020-XXX-002 (Failed Hot-Swap Slot 2
PCI Latch test)
020-XXX-003 (Failed Hot-Swap Slot 3
PCI Latch test)
020-XXX-004 (Failed Hot-Swap Slot 4
PCI Latch test)
030-XXX-000 (Failed Internal SCSI
interface test)
035-XXX-099
035-XXX-S99 (Failed RAID test on PCI
slot S, check System Error Log before
replacing a FRU)
035-XXX-SNN (Check System Error Log
before replacing a FRU,
failing fixed disk)
035-253-S99 (RAID adapter
initialization failure)
075-XXX-000 (Failed Power Supply test) 1.
089-XXX-001 (Failed Microprocessor
test)
116
Hardware Maintenance Manual: xSeries 340 Model 6RY
1. System Board
1. System Board
1. System Board
1. System Board
1. System Board
2. Make sure parrallel port is not disabled.
3. Re-run USB external loopback test.
1. System Board
2. Remove USB devices from USB1 and USB2.
3. Re-run USB external loopback test.
1. System Board
1.
PCI Hot-Swap Latch Assembly
2. System Board
1. PCI Hot-Swap Latch Assembly
2. System Board
1. PCI Hot-Swap Latch Assembly
2. System Board
1. PCI Hot-Swap Latch Assembly
2. System Board
1. System Board
1. No adapters were found.
2. If adapter is installed re-check connection.
1. Adapter
2. SCSI Backplane
3. Cable
1. Fixed Disk with SCSI ID NN on RAID adapter in PCI slot S.
NN = SCSI ID of
1. ServeRAID Adapter in slot S is not configured properly. Obtain
the basic and extended configuration status and refer to the
ServeRAID Hardware Maintenance Manual for more information.
2. Cable
3. SCSI Backplane
4. Adapter
Power Supply
1. VRM for Microprocessor 1
2. Microprocessor 1
FRU/Action