Table of Contents
Advertisement
Network settings
Set when networking with a computer.
Note
●
The DIGITAL LINK-related menus are displayed when
the DIGITAL LINK Terminal Board is attached to the
expansion slot (SLOT).
[Network settings] submenu will be displayed
●
For the main software version of 1.5000 and later, the
current setting is displayed to the right of [LAN setup].
Lower than Version 1.5000 (before IPv6
compatible)
Network settings
Administrator account settings
Network control
PJLink settings
AMX D. D.
Crestron Connected™
LAN setup
Network status
DIGITAL LINK mode
DIGITAL LINK status
DIGITAL LINK menu
Extron XTP
Auto display name
Display name
USB memory network settings
LAN control protocol
Reset
Version 1.5000 and later (after IPv6 compatible)
Network settings
Administrator account settings
Network control
PJLink settings
AMX D. D.
Crestron Connected™
LAN setup
Network status (IPv4)
Network status (IPv6)
DIGITAL LINK mode
DIGITAL LINK status
DIGITAL LINK menu
Extron XTP
Auto display name
Display name
USB memory network settings
LAN control protocol
Reset
Off
Off
Off
Auto
Off
Off
EQ2-000
Permit
Protocol 2
Off
Off
Off
IPv4 & IPv6
Auto
Off
Off
EQ2-000
Permit
Protocol 2
■
[Administrator account settings]
Configure the administrator account settings.
Administrator account settings
Password policy
User name
Password
Save
[Password policy]:
Precautions for password settings of this item will be
displayed in a new window.
[User name]:
The keyboard for setting the user name is displayed.
Enter the user name.
●
Entering characters (see page 177)
[Password]:
The keyboard for setting the password is displayed.
After entering the password, select [Ok]; the
confirmation screen is displayed. Enter the password
again and select [Ok]; the password is determined.
[Save]:
Saves the user name and password determined
above in the display unit.
Note
●
Once determined, it is necessary to enter the user
name and password to display the settings.
■
[Network control]
Set when controlling with the unit's LAN terminal.
[Off]:
Invalidates control with LAN terminal.
(In this case, the power consumption of Standby
condition (when the power is turned off with the
remote control) will be slightly reduced.)
[On]:
Controls via LAN using the LAN terminal. The
power indicator lights purple when the power is
turned off with the remote control (standby).
Note
●
When using the LAN control function which is
described in "Using Network Function" (see page
101 ‒ 126), set this function to [On].
●
Even if the setting is set to [Off], the Web browser
control screens that do not control this unit (display
information [Status], detailed settings [Detailed set
up] and password change [Change password])
operate.
●
To enable the operation, set [Quick start] to [On].
●
When [Quick start] is set to [Off], the power can
be turned off via network control even if [Network
control] is set to [On]. However, the power cannot
be turned on from standby state with the exception
after a wake-up message (magic packet) is sent
from the network equipment in the network. To
control both, it is necessary to set both [Quick start]
and [Network control] to [On] respectively.
dispadmin
English
79
Advertisement
Table of Contents
