Network Settings - Panasonic TH-55SQ1W Operating Instructions Manual

● Depending on the network environment,
synchronization may be largely lost.
● Synchronization is not possible if a router is placed
between the displays with [Parent] and [Child] set.
● Synchronization is not possible via a wireless LAN.
■
[NTP status]
Displays the current [NTP synchronization] and [Time
zone] (see page 104) settings.
Note
●
When [NTP synchronization] is set to [On], and if
[Synchronize display] and [Parent or child setting]
are set to [On] and [Child] respectively, [NTP
synchronization] shows [--], and the off-operation is
performed.
●
When [NTP synchronization] is [On], date and time
cannot be set.
●
The settings for [NTP synchronization] and [Time
zone] cannot be changed with this menu. Change the
settings with WEB browser. (see page 104)
●
[NTP synchronization] operates only in power-on
state or in schedule standby state.

Network settings

Set when networking with a computer.
[Network settings] submenu will be displayed.
Network settings
Serial control
Network control
Auto display name
Display name
LAN setup
Network status
DIGITAL LINK mode
DIGITAL LINK(Ethernet control)
DIGITAL LINK status
DIGITAL LINK menu
AMX D. D.
Crestron Connected™
Extron XTP
USB memory network settings
LAN control protocol
Reset
■
[Serial control]
Selects the RS232-C control terminal.
[SERIAL IN]:
Controls using the SERIAL IN terminal of the
display.
[DIGITAL LINK]:
Controls via the optional device that supports
DIGITAL LINK output (ET-YFB100G, ET-
YFB200G) and the DIGITAL LINK / LAN terminal.
[SLOT]:
Controls via the function board inserted to the
SLOT of this unit.
■
[Network control]
Set when controlling with the unit's LAN terminal.
[On]:
Controls via LAN using the LAN terminal. The
power indicator lights orange when the power is
turned off with the remote control (standby).
[Off]:
Invalidates control with LAN terminal.
(In this case, the power consumption of Standby
condition (when the power is turned off with the
remote control) will be slightly reduced.)
Note
●
When using the LAN control function which is
described in "Using Network Function" (see page
91 ‒ 109), set this function to [On].
●
Even if the setting is set to [Off], the Web browser
control screens that do not control this unit (display
information [Status], detailed settings [Detailed set
up] and password change [Change password])
operate.
SERIAL IN
Off
Off
SQ1-000
Auto
Enable
Off
Off
Off
Permit
Protocol 2
English
77