●
Depending on the network environment,
synchronization may be largely lost.
●
Synchronization is not possible if a router is placed
between the displays with [Parent] and [Child] set.
●
Synchronization is not possible via a wireless LAN.
■
[NTP status]
Displays the current [NTP synchronization] and [Time
zone] (see page 99) settings.
Note
●
When [NTP synchronization] is set to [On], and if
[Synchronize display] and [Parent or child setting]
are set to [On] and [Child] respectively, [NTP
synchronization] shows [--], and the off-operation is
performed.
●
When [NTP synchronization] is [On], date and time
cannot be set.
●
The settings for [NTP synchronization] and [Time
zone] cannot be changed with this menu. Change the
settings with WEB browser. (see page 99)
●
[NTP synchronization] operates only in power-on
state or in schedule standby state.
74
English
Network settings
Set when networking with a computer.
Note
●
The DIGITAL LINK-related menus are displayed when
the DIGITAL LINK Terminal Board is attached to the
expansion slot (SLOT).
[Network settings] submenu will be displayed.
Network settings
Administrator account settings
Network control
PJLink settings
AMX D. D.
Crestron Connected™
LAN setup
Network status
DIGITAL LINK mode
DIGITAL LINK status
DIGITAL LINK menu
Extron XTP
Auto display name
Display name
USB memory network settings
LAN control protocol
Reset
■
[Administrator account settings]
Configure the administrator account settings.
Administrator account settings
Password policy
User name
Password
Save
[Password policy]:
Precautions for password settings of this item will be
displayed in a new window.
[User name]:
The keyboard for setting the user name is displayed.
Enter the user name.
●
Entering characters (see page 165)
[Password]:
The keyboard for setting the password is displayed.
After entering the password, select [Ok]; the
confirmation screen is displayed. Enter the password
again and select [Ok]; the password is determined.
[Save]:
Saves the user name and password determined
above in the display unit.
Note
●
Once determined, it is necessary to enter the user
name and password to display the settings.
Off
Off
Off
Auto
Off
Off
EQ2-000
Permit
Protocol 2
dispadmin