Table of Contents
Advertisement
Identifying Controls
Display
98-inch model
●
Slide the lever on the rear panel to eject the power
indicator and remote control sensor.
To store them, slide the same lever, or directly push in
the bottom surface of the remote control sensor.
Note
●
For normal use, pull out the power indicator and
remote control sensor from the edge side of the
main unit by operating the lever on the rear panel.
Depending on the setup condition such as when
using the multi display, store them in the main unit.
86-inch model
75-inch model
55-inch model
50-inch model
1 Power Indicator / Remote control sensor
The Power Indicator will light.
When the power of the unit is ON (Main Power On
/ Off button (
): ON)
●
Picture is displayed: blue
65-inch model
43-inch model
●
When the unit enters the standby mode using the
following functions: purple
Standby state with the "Quick start" function
•
About "Quick start" function, see page 60.
Standby state with the "Power management"
•
function
About "Power management" function, see page 65.
Standby state with [HDMI-CEC control] set to
•
[Enable] and at least one [Link function] set to
other than [Disable]
About [HDMI-CEC control] setting and [Link
function], see page 69.
Standby state with [Network control] set to [On]
•
About "Network control" settings, see page 79.
Standby state with the "SLOT standby" function
•
About "SLOT standby" function, see page 100.
Standby state during schedule play mode
•
About "Schedule play mode", see page 136.
●
Standby state in conditions other than the above:
orange
When the power of the unit is OFF (Main Power
On / Off button: OFF): No light
Note
●
Even if the unit is turned off with the power
indicator off, some of the circuits are in power-on
status.
●
When the power indicator is purple, power
consumption during standby is generally larger
than that of when the power indicator is orange.
●
When [Power LED light-up setting] is set to [Off],
the power indicator does not light up. (see page 98
[Power LED light-up setting])
●
For the power button, the operation with [POWER
button control setting] set to [Off] is described
unless otherwise mentioned. (see page 98
[POWER button control setting])
33
English
Advertisement
Table of Contents
