Table of Contents
Advertisement
When using
Be careful of the movable structure of the power
indicator and remote control sensor (98-inch model
only).
As factory default, the power indicator and remote
•
control sensor are stored in the main unit. For normal
use, pull out the remote control sensor from the edge
side of the main unit by operating the lever on the
rear panel. Depending on the setup condition such as
when using the multi display, store the remote control
sensor in the main unit. (see page 33)
Image retention may occur.
If you display a still picture for an extended period, the
•
image might remain on the screen. However, it will
disappear when a general moving picture is displayed
for a while.
When polarization sunglasses are worn, the screen
display may be invisible.
This phenomenon occurs due to deflection
•
characteristics of the liquid crystal panel. This is not a
malfunction.
Red, blue or green dots on the screen are a liquid
crystal panel-specific phenomenon. This is not a
malfunction.
Although the liquid crystal display is manufactured
•
with high-precision technology, always-lighting dots or
non-lighting dots may appear on the screen. This is
not a malfunction.
Inch model
98
86
75
65
55
50
43
*: Calculated in sub-pixel units according to the
ISO9241-307 standard.
Depending on the temperature or humidity
conditions, uneven brightness may be observed.
This is not a malfunction.
This unevenness will disappear while applying current
•
continuously. If not, consult the distributor.
If the Display is not going to be used for any
prolonged length of time, unplug the power supply
plug from the wall outlet.
When storing the product for long periods with no
•
power supplied, do not store it in a location exposed
to direct sunlight.
If the power is instantaneously interrupted or
stopped, or if the power voltage is instantaneously
lowered, the Display may not operate normally.
In this case, turn off the power of the Display and the
•
connected devices once, and then turn on the power
again.
Picture noise may occur if you connect / disconnect
the cables connected to the input terminals you
are currently not watching, or if you turn the power
of the video equipment on / off, but it is not a
malfunction.
12
English
Dot omission ratio*
0.00011% or less
0.00009% or less
0.00007% or less
0.00005% or less
0.00005% or less
0.00005% or less
0.00005% or less
Notes on Using Wired LAN
When setting up the Display at a place, where
electric statistic occurs often, take a sufficient
antistatic measure before start using.
When the Display is used at a location, where static
•
electricity occurs often, such as on a carpet, a wired
LAN communication is disconnected more often.
In that case, remove static electricity and the noise
source that may cause problems with an antistatic
mat, and re-connect the wired LAN.
In rare cases, the LAN connection is disabled due
•
to static electricity or noise. In that case, turn off the
power of the Display and the connected devices once
and then re-turn on the power.
The Display may not work properly due to strong
radio wave from the broadcast station or the radio.
If there is any facility or equipment, which outputs
•
strong radio wave, near the installation location, set
up the Display at a location sufficiently far from the
source of the radio wave. Or, wrap the LAN cable
connected to the LAN terminal by using a piece of
metal foil or a metal pipe, of which is grounded at
both ends.
Request Regarding Security
When using this unit, take safety measures against
the following incidents.
Personal information being leaked via this unit
•
Unauthorized operation of this unit by a malicious
•
third party
Interfering or stopping of this unit by a malicious third
•
party
Take sufficient security measures. (see page 107,
113)
Set a password for the LAN control and restrict the
•
users who can log in.
Make your password difficult to guess as much as
•
possible.
Change your password periodically.
•
Panasonic Connect Co., Ltd. or its affiliate companies
•
will never ask for your password directly. Do not
divulge your password in case you receive such
inquiries.
The connecting network must be secured by a
•
firewall, etc.
When disposing the product, initialize the data before
•
disposing. ([Shipping] (see page 181))
Advertisement
Table of Contents
