Table of Contents
Advertisement
4. Set the controller module aside in a safe place.
5. Repeat these steps for the second controller module in the chassis.
Step 3: Move drives to the replacement chassis
Move the drives from each drive bay opening in the impaired chassis to the same bay opening in
the replacement chassis.
1. Gently remove the bezel from the front of the system.
2. Remove the drives:
a. Press the release button on the opposite side of the LEDs.
b. Pull the cam handle to its fully open position to unseat the drive from the midplane, and
then gently slide the drive out of the chassis.
The drive should disengage from the chassis, allowing it to slide free of the chassis.
When removing a drive, always use two hands to support its weight.
Drives are fragile. Handle them as little as possible to prevent damage to
them.
3. Align the drive from the impaired chassis with the same bay opening in the replacement
96
Advertisement
Table of Contents
