Table of Contents
Advertisement
3. Recable the system, as needed.
If you removed the media converters (QSFPs or SFPs), remember to reinstall them if you are
using fiber optic cables.
4. If the power supplies were unplugged, plug them back in and reinstall the power cable
retainers.
5. Complete the reinstallation of the controller module:
a. With the cam handle in the open position, firmly push the controller module in until it meets the
midplane and is fully seated, and then close the cam handle to the locked position.
Do not use excessive force when sliding the controller module into the
chassis to avoid damaging the connectors.
The controller begins to boot as soon as it is seated in the chassis.
b. If you have not already done so, reinstall the cable management device.
c. Bind the cables to the cable management device with the hook and loop strap.
d. Reconnect the power cables to the power supplies and to the power sources, and then turn on
the power to start the boot process.
e. Halt the controller at the LOADER prompt.
91
Advertisement
Table of Contents
