Lenovo ThinkSystem DM3010H Hardware Installation And Maintenance Manual page 45

Table of Contents

Advertisement

efi
a. Copy the
efi
The USB flash drive should have the efi folder and the same Service Image (BIOS)
version of what the impaired controller is running.
b. Remove the USB flash drive from your laptop.
3. Install the controller module:
a. Align the end of the controller module with the opening in the chassis, and then gently push
the controller module halfway into the system.
b. Recable the controller module.
When recabling, remember to reinstall the media converters (SFPs) if they were removed.
4. Insert the USB flash drive into the USB slot on the controller module.
Make sure that you install the USB flash drive in the slot labeled for USB devices, and not in the
USB console port.
5. Push the controller module all the way into the system, making sure that the cam handle clears
the USB flash drive, firmly push the cam handle to finish seating the controller module, push the
cam handle to the closed position, and then tighten the thumbscrew.
The controller begins to boot as soon as it is completely installed into the chassis.
6. Interrupt the boot process to stop at the LOADER prompt by pressing Ctrl-C when you see
Starting AUTOBOOT press Ctrl-C to abort....
If you miss this message, press Ctrl-C, select the option to boot to Maintenance mode, and
then halt the controller to boot to LOADER.
7. For systems with one controller in the chassis, reconnect the power and turn on the power
supplies.
The system begins to boot and stops at the LOADER prompt.
8. Set your network connection type at the LOADER prompt:
◦ If you are configuring DHCP:
The target port you configure is the target port you use to communicate
with the impaired controller from the healthy controller during var file
system restore with a network connection. You can also use the e0M port
in this command.
◦ If you are configuring manual connections:
-gw=gateway-dns=dns_addr-domain=dns_domain
folder to the top directory on the USB flash drive.
ifconfig e0a -auto
ifconfig e0a -addr=filer_addr -mask=netmask
39

Advertisement

Table of Contents
loading

This manual is also suitable for:

7dcv

Table of Contents