Table of Contents
Advertisement
4. Turn on the power switches to both nodes.
Initial booting may take up to eight minutes.
1. Assign an initial node management IP address to one of the nodes.
If the
Then...
management
network has
DHCP...
Configured
Record the IP address assigned to the new controllers.
Not configured
a. Open a console session using PuTTY, a terminal server, or the
b. Enter the management IP address when prompted by the script.
2. Using Storage Manager on your laptop or console, configure your cluster:
a. Point your browser to the node management IP address.
The format for the address is https://x.x.x.x.
b. Enter the data from your Cluster Configuration Worksheet.
When using Guided Setup to configure the cluster, ensure that your
service processor addresses are configured in an isolated network
so that the addresses are not routable.
3. After you have completed the initial configuration, go to
Manager for DM Series Documentation Resources
additional features in ONTAP.
A
B
1
2
equivalent for your environment.
Check your laptop or console's online help if you
do not know how to configure PuTTY.
ONTAP & ThinkSystem Storage
for information about configuring
29
Advertisement
Table of Contents
