If the system-level
diagnostics tests...
Were completed without any
failures
If the failures persist after repeating the steps, you need to replace the hardware.
122
Then...
There are no hardware problems and your storage system
returns to the prompt.
a. Clear the status logs by entering the following command:
sldiag
device
devtype|mb|slot_slotnum_]
b. Verify that the log is cleared by entering the following
command:
sldiag
devtype|mb|slot_slotnum_]
The following default response is displayed:
SLDIAG: No log messages are present.
c. Exit
Maintenance
command:
halt
d. Enter the following command at the Loader prompt to boot
the storage system:
system-level diagnostics.
clearstatus
device
status
mode
by
entering
You have completed
boot_ontap
[-dev
[-dev
the
following