Chassis Bulkhead Replacement; Remove The Bulkhead - Lenovo ThinkSystem SN550 Maintenance Manual

• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-B4_LYuT9X1MRWBU6UzX9gO
• Youku: http://list.youku.com/albumlist/show/id_50481482
Figure 19. Bezel installation
Step 1. Position the bezel on the front of the compute node.
Step 2. Hook the bottom edge of the bezel on the front of the compute node; then, rotate the top of the
bezel toward the compute node.
Step 3. Press the bezel securely against the compute node to snap it in place.
Note: Make sure that the bezel is pressed flat against the chassis. Lifting up slightly on the top
edge of the bezel as you press it might make it easier to seat the clips.
Step 4. Install any removed storage drives or hard disk drive bay fillers (see "Install a 2.5-inch hot-swap
drive" on page 27 ).
Step 5. Close the front handle.

Chassis bulkhead replacement

Use the following information to remove and install the chassis bulkhead.

Remove the bulkhead

Use this information to remove the bulkhead.
Before you remove the bulkhead, complete the following steps:
1. Read "Safety" on page iii and "Installation Guidelines" on page 21 to ensure that you work safely.
.
Chapter 3 Hardware replacement procedures
37