Table of Contents
Advertisement
clicks into place.
Be sure to close the cam handle slowly so that it aligns correctly with the face of the
drive.
7. Verify that the drive's activity (green) LED is illuminated.
When the drive's activity LED is solid, it means that the drive has power. When the drive's
activity LED is blinking, it means that the drive has power and I/O is in progress. If the
drive firmware is automatically updating, the LED blinks.
8. If you are replacing another drive, repeat Steps 3 through 7.
9. If you disabled automatice drive assignment in Step 1, then, manually assign drive
ownership and then reenable automatic drive assignment if needed.
a. Display all unowned drives:
You can enter the command on either controller module.
b. Assign each drive:
You can enter the command on either controller module.
You can use the wildcard character to assign more than one drive at once.
c. Reenable automatic drive assignment if needed:
node_name -autoassign on
You must reenable automatic drive assignment on both controller modules.
10. Return the failed part to Lenovo, as described in the RMA instructions shipped with the kit.
Option 2: Replace HDD
1. If you want to manually assign drive ownership for the replacement drive, you need to
disable automatic drive assignment replacement drive, if it is enabled
You manually assign drive ownership and then reenable automatic drive
assignment later in this procedure.
a. Verify whether automatic drive assignment is enabled:
You can enter the command on either controller module.
If automatic drive assignment is enabled, the output shows
column (for each controller module).
b. If automatic drive assignment is enabled, disable it:
-node node_name -autoassign off
72
storage disk show -container-type unassigned
storage disk assign -disk disk_name -owner owner_name
storage disk option modify -node
storage disk option show
in the "Auto Assign"
on
storage disk option modify
Advertisement
Table of Contents
