Connecting The Lan And Serial Port Cables - IBM IntelliStation R Pro Hardware Maintenance Manual

Connecting the LAN and serial port cables

66
Hardware Maintenance Manual: xSeries 330 Type 8674 and IntelliStation R Pro Type 6851
Connect one end of the power cord 4 to the connector on the power supply
2.
adapter 3 .
Connect the other end of the power cord 5 to a properly grounded electrical
3.
outlet.
Note: Alternately, you can connect one end of the universal power cord to the
power supply adapter; then, connect the other end to a power distribution
unit (PDU) or to an uninterruptible power supply (UPS).
4. Make sure that the Remote Supervisor Adapter power LED is green. For the
location of the power LED, see the illustration in "Cabling the Ethernet LAN
port" on page 67.
Continue with "Connecting the LAN and serial port cables".
You can manage your server remotely using the connections and user interfaces that
are described in Table 9. Choose the interface method you want to use to perform
remote management; then, perform the indicated cabling procedure.
If you plan to set up an ASM interconnect network, go to "Planning and cabling your
interconnect network" on page 77 for instructions about cabling the ASM interconnect
port and setting up the network. Then, return here to continue the cabling procedures.
Table 9. Cabling tasks to enable remote access to the Remote Supervisor Adapter.
User interface to Remote
Supervisor Adapter
ASM Web interface using
the HTTP protocol
Text-based user interface
using the TELNET
protocol
Connection to Remote
Supervisor Adapter
LAN using the Ethernet port
For the cabling procedure, see:
"Cabling the Ethernet LAN
port" on page 67