Table of Contents
Advertisement
the same manufacturer. The battery contains lithium and can explode if not
properly used, handled, or disposed of.
Do not:
•
•
•
Dispose of the battery as required by local ordinances or regulations.
To replace the battery:
1.
2.
3.
4.
5.
6.
24
Hardware Maintenance Manual: xSeries 330 Type 8674 and IntelliStation R Pro Type 6851
Throw or immerse into water
Heat to more than 100°C (212°F)
Repair or disassemble
Read "Before you begin" on page 46, and follow any special handling and
installation instructions supplied with the replacement battery.
Turn off the server/workstation and peripheral devices and disconnect all
external cables and power cords.
Remove the server/workstation from the rack (see "Rack installation" on page
47).
Remove the cover (see "Removing the cover" on page 49).
Remove the battery:
a.
Use one finger to lift the battery clip over the battery.
b. Use one finger to slightly slide the battery out from its socket. The spring
mechanism will push the battery out toward you as you slide it from the
socket.
c.
Use your thumb and index finger to pull the battery from under the battery
clip.
d. Ensure that the battery clip is touching the base of the battery socket by
pressing gently on the clip.
Insert the new battery:
a.
Tilt the battery so that you can insert it into the socket, under the battery clip.
b. As you slide it under the battery clip, press the battery down into the socket.
Advertisement
Table of Contents
