Table of Contents
Advertisement
5.
6.
7.
8.
9.
10. Install the cover see "Removing the cover" on page 49.
11. Turn on the server/workstation.
52
Hardware Maintenance Manual: xSeries 330 Type 8674 and IntelliStation R Pro Type 6851
Remove the expansion-slot cover.
Refer to the documentation that comes with your adapter for any cabling
instructions.
Attention: You should route adapter cables before you install the adapter.
Set any jumpers or switches as described by the adapter manufacturer.
Install the adapter:
Note: When installing an adapter into slot 2, skip steps a and d.
a.
Open the adapter retention latch by pushing the blue tab to release it. Then
push the latch up to the full open position.
b. Carefully grasp the adapter by its top edge or upper corners, and align it with
the connector on the PCI riser-card.
c.
Press the adapter firmly into the riser-card connector.
Attention: When you install an adapter, be sure the adapter is correctly
seated in the riser-card connector before you turn on the server/workstation.
Improperly seated adapters might cause damage to the system board, the
riser-card, or the adapter.
d. Push down on the blue adapter retention latch until it clicks into place,
securing the adapter.
e.
Replace the expansion slot clip by sliding it down until it latches into place
and holds the adapter securely.
Connect the internal cables to the adapter.
Attention: Route cables so that they do not block the flow of air from the fans.
Note: When installing a ServeRAID adapter remove the cable from the SCSI
connector (J4) on the system board and attach it to the ServeRAID adapter.
Air flow
Advertisement
Table of Contents
