IBM IntelliStation R Pro Hardware Maintenance Manual page 96

2.
3.
4.
5.
6.
7.
88
Hardware Maintenance Manual: xSeries 330 Type 8674 and IntelliStation R Pro Type 6851
Turn off the server/workstation and peripheral devices and disconnect the power
cord and all external cables; then remove the cover (see "Removing the cover" on
page 49 for details).
Remove the clear shield from the server/workstation and store it in a safe place.
Lift up the microprocessor release lever and remove the terminator card from the
microprocessor connector. (After you remove the new microprocessor from the
static-protective package, place the terminator card in the bag and store it in a safe
place. You will need to install the terminator card again if you ever remove the
microprocessor and do not replace the microprocessor.)
Install the microprocessor:
a. Touch the static-protective package containing the new microprocessor to any
unpainted metal surface on the server/workstation; then, remove the
microprocessor from the package.
b. Orient the microprocessor over the microprocessor connector as shown in the
illustration. Carefully press the microprocessor into the connector.
Note: To avoid bending the pins on the microprocessor, do not use excessive
force when pressing it into the connector.
Microprocessor
orientation indicator
Microprocessor-
release lever
Push the microprocessor release lever down to lock the microprocessor into place.
Install the heat sink on the microprocessor:
a. Peel the plastic protective strip off the bottom of the heat sink. Make sure the
square of thermal material is still on the bottom of the heat sink.
b. Align and place the heat sink on top of the microprocessor.
Note: Locate the slot in the channel of the heat sink. Orientate the heat sink
so the slot will be at the rear of the server/workstation.
c. Align and place the clip over the heat sin; then, snap the clip into place over
the heat sink with the heat sink release lever in the up position.
Microprocessor
Microprocessor
connector
Rear of server